LavaTap 48mm Dual Flush Push Button with Push Rods, Chrome - Single, 5 or 10 Pack

Product description

This 48mm dual flush push button is a straight replacement for a worn, cracked or sticking round button on a close coupled or back to wall toilet cistern. It suits dual flush valves that are worked by two push rods from above. The rods screw into the underside of the button and adjust to the height of your valve, and the plastic lock nut clamps the button firmly to the cistern lid.

Before you order, lift the cistern lid and check three things. First, the size: this button has a 48mm threaded body, so measure the old button body or the hole in your lid. Second, the valve: it must be a dual flush valve worked by two push rods. Cable-operated valves, levers and pull chains need a different part. Third, the depth: measure from the underside of the lid to the top of the valve plungers so you know the rods will reach.

Fitting takes a few minutes. Take off the old button and lock nut, set the two threaded rods to the right height for your valve, pass the body through the lid and tighten the lock nut by hand. Put the lid back on and test both the half and the full flush. The small button gives a half flush and the large button a full flush, so the household only uses the water each flush needs.

In the bag: one dual flush push button with chrome effect cap, threaded body, plastic lock nut and two threaded push rods. Choose Single, 5 Pack or 10 Pack above.