• Check before you buy: fits a 1.5in or 2in cistern outlet and an 18 to 47mm button hole in the lid, with 80mm width and 255mm clear height inside the cistern
• Fits close-coupled and low-level cisterns: not for one-piece toilets, most concealed cisterns, slimline cisterns, or lever and siphon without modification
• Two outlet sizes in one kit: 1.5in and 2in basket and overflow supplied, twist the basket off the bayonet to swap to the size your cistern needs
• Dual flush push button: 350mm cable and button, fits a 38 to 47mm lid hole straight in or an 18 to 37mm hole using the surface mount adaptor
• Adjustable flush and overflow: blue slider sets the short flush and red slider the long flush, a higher slider uses less water, and the overflow telescopes from 255 to 400mm
• In the box: flush valve, spare basket and overflow, cable and switch box, chrome push button, chrome collar, two rubber grommets, WRAS approved

• Check before you buy: fits a 1.5in or 2in cistern outlet and an 18 to 47mm button hole in the lid, with 80mm width and 255mm clear height inside the cistern
• Fits close-coupled and low-level cisterns: not for one-piece toilets, most concealed cisterns, slimline cisterns, or lever and siphon without modification
• Two outlet sizes in one kit: 1.5in and 2in basket and overflow supplied, twist the basket off the bayonet to swap to the size your cistern needs
• Dual flush push button: 350mm cable and button, fits a 38 to 47mm lid hole straight in or an 18 to 37mm hole using the surface mount adaptor
• Adjustable flush and overflow: blue slider sets the short flush and red slider the long flush, a higher slider uses less water, and the overflow telescopes from 255 to 400mm
• In the box: flush valve, spare basket and overflow, cable and switch box, chrome push button, chrome collar, two rubber grommets, WRAS approved

The FlushDaddy NP254 is a WRAS approved dual flush drop valve for cisterns with a 1.5 inch or 2 inch outlet. It suits many standard UK close-coupled and low-level toilets. It is not a universal fit, so please check all four measurements below before ordering. Before you buy, confirm all four: - Cistern outlet hole: 1.5 inch or 2 inch - Button hole in the cistern lid: anywhere from 18mm to 47mm - Clear width inside the cistern: 80mm - Clear height inside the cistern: 255mm minimum The push button mounts two ways, so the hole in your lid does not have to be an exact size. A 38 to 47mm hole takes the button straight in for a flush finish. An 18 to 37mm hole takes the surface mount adaptor, with the button sitting over the hole and the backnut clamping underneath. The button can also be mounted on a wall. It runs on a 350mm cable and switch box, and two rubber grommets are supplied for spindles that do not fit first time. The overflow is telescopic and adjusts from 255mm to 400mm, measured from the bottom of the telescopic pole, so it can be set to suit the height of your cistern. Flush volume adjusts too: the blue slider sets the short flush and the red slider the long flush, and moving a slider higher uses less water. Both outlet sizes are supplied in the box. The basket and overflow twist off a bayonet fitting, so you can swap between the 1.5 inch and the 2 inch to match your cistern. This valve replaces a drop valve. It is not a direct replacement for a traditional siphon, and it will not fit one-piece toilets, most concealed cisterns, or slimline cisterns. In the box: flush valve, spare basket and overflow, cable and switch box, chrome push button, chrome collar, two rubber grommets and instructions. WRAS approved and backed by a 5 year guarantee. Supplied by LavaTap. If you are unsure, measure your existing valve and your cistern before ordering.