The LavaTap 3-in-1 boiling water tap kit, with a swan neck swivel spout in brushed brass. It gives boiling water at up to 98 °C, plus everyday hot and cold, from one tap.

In the box. The LavaTap 3-in-1 tap, the LavaTap 2.4 L boiling water tank and the filter. The tap fits a single 35 mm hole, deck mounted, and connects to 1/2" BSP hot and cold supplies with the flexible hoses included. The tank sits under the sink and plugs into a 13A socket. The T adaptor that feeds the filter from your cold supply is in the box too. Isolation valves on your hot and cold supplies are not included, so your installer fits them if you don't have them.

How to use it. For boiling water, press the button on the left handle, hold it and turn. For hot or cold, turn the right handle. Set the boiling temperature from 45 to 98 °C on the tank.

At least 2 years on the whole kit. Bought as a full kit, every part of your LavaTap system is guaranteed for at least 2 years, and the tap body for life, as long as it is fitted by a qualified installer, you register within 30 days of installation, you change the filter at least every 6 months with a genuine filter, and you follow the other guarantee terms.

Your guarantee. The tap body is covered for life, the cartridge for 10 years and the O-rings for 5 years. The tank's heating element is covered for 5 years, and its sensor and control board for 2 years. Cover runs from installation. Register within 30 days of installation, using the guarantee card in the box, because your cover is not active until you do. Cover is for manufacturing faults in normal domestic use, held by the original buyer. Your statutory rights are unaffected.

Keeping your cover valid. Have it fitted by a qualified installer, working to current regulations, with genuine LavaTap parts throughout. Fill the tank and run the tap until the flow is steady before you plug it in. Hand-tighten the 3/8" tank connections. Fit the tank indoors (0 to 35 °C), upright and uncovered, with 10 to 15 cm clear on three sides. Keep the water pressure between 1.5 and 5 bar. Change the filter at least every 6 months with a genuine filter, and keep the receipts.

Not covered. Incorrect or DIY installation, dry-fired elements, limescale and hard-water damage, frost damage, non-genuine parts or filters, missed filter changes, general wear and tear, and harsh or abrasive cleaning.

Specifications. In the box: 3-in-1 tap, 2.4 L tank, filter. Spout: swan neck, swivel. Tap height: 365 mm. Tap hole: 35 mm, single hole, deck mounted. Supply: 1/2" BSP, flexible hoses included. Boiling: up to 98 °C, 45–98 °C set on the tank. Flow at 3 bar: boiling 1.8 L/min, mixed 13.1 L/min. Tank: 2.4 L, 1.5 kW, 230 V, 13A plug, 240 W × 330 H × 220 D mm. Water pressure: 1.5 to 5 bar. Finish: Brushed brass.