• 2 channel Danfoss programmer - Direct replacement for Danfoss FP715 with no wiring required
• 7 Day, 5/2 Day & 24Hr schedules
• 1, 2 or 3 heating periods (2, 4 or 6 events)
• Auto, Boost, On or Off, Holiday Modes
• Danfoss Part No 087N7885

The Danfoss FP720 V2 provides flexible time settings to suit your lifestyle whilst ensuring the heating is only called for during the normal home routine. The timers are used to switch your gas boiler either directly or via motorised zone valves and when used together with room thermostats can provide full heating and comfort control. The FP720 includes a large, easy to read backlit display with straightforward intuitive layout. Current day, time and on / off period is shown in the large top section along with icons showing status of the output channels. Easy channel override by pressing and holding the relevant labelled button for 3 seconds. At the bottom of the display the channel setting is shown where the user can select for Auto, +1hr Boost or Constant On or Off control. This is shown for both channels on FP720. FP720 can be setup to control heating and domestic hot water channels with separate schedules or 2 heating zones. Again, the display differentiates between these setups and indicates the channel type on the display. This is a direct replacement for the Danfoss programmer FP715SI. Simply disconnect power to the unit, loosen the 2 securing screws and remove the FP715SI from the backplate. The FP720 Danfoss programmer will then push in place. Tighten the screws for the backplate and reconnect power.